To Install the Tape from A to B

Index Next

THE EASIEST AND SIMPLEST WAY TO INSTALL HORSEGUARD TRADITIONAL FENCE
FROM THE BUCKLE N°1 TO THE BUCKLE N°2

Install one mile of HorseGuard Tape in less than 30 minutes !

Tensioning the tape in one go

Step 1 : Attach the tape to buckle N°1


Make a loop with the tape. Push it through the buckle. Insert the tang in the loop	Pull the end of the tape

To lock it, go again through the stainless steel buckle	Secure the tail with the clip : (the clip is located between the cap and the base of the tensioner)

Unrolling the spool of tape:

Unroll the tape to
the next tensioner #36W

Pull the WHOLE tape by hand
(even a mile of tape is easy to pull)

Step 2 : Attach the tape to buckle N°2

Set the tape in the #36W buckle.
Pull and set the final tension of your fence from one tensioner #36W to the next #36W.
Cut the tape 8" from the buckle
Secure the tail with the clip

Step 3 : How to secure the tape into the new #8 insulators

1- Once it has been attached onto the post which can be wood, pipe, fiberglass or Tpost.	2- Position the tape on it.
3-Close the cap and screw in the bottom #8 peg.	4- Then firmly screw in the other #8 peg but do not over tighten.

TO TENSION AND RE-TENSION THE TAPE

To stretch & re-stretch the tape #TSP Once you have tried our Tape Stretching Pliers you will wonder how you could have been able to stretch the tape without them before... They really make the job so easy… But do not forget to loosen the Pegs to free the tape before pulling it with the pliers #TSP

TSP

Tape Stretching Pliers

13.52

To loosen the Tape


Take the tail of the tape out of the buckle.	Slacken the fence tape by pushing it with the palm of your hand. It will slacken all by itself.

Prev. Index

Our Websites around the world

Contact HorseGuard