HORSEGUARD The Original Electric Tape Fence System
The Splicer Buckle #24 and the Keeper Clip #CLIP
|
It joins 2 ends of tape together, ensuring good electrical
contact between all the stainless steel threads of the tape,
avoiding the sparks created by voltage differences. If you
notice any areas on your tape that sparks, cut your tape and
install a splicer buckle. Make sure you keep a couple spare
splicer buckles around, so that in the event of unexpected fence breaks, the tape can
be easily repaired. The #24 allows an electrical connection anywhere on the tape, and
also allows you to stretch the tape again. The keeper clip holds the ends of the tape
in place. |
The Cable #28M + 1 connector #59G
|
or
To ensure
a good
connection
from the
charger
to your
fence line,
you need
either
a 5 feet
long #59L
connector
wire
or
order 28M cable by the foot
to your desired length along
with a connector #59G.
You crimp the connector
onto the tensioner #36W |
The connector #59L
|
Interconnector #59H
It transfers the
power from
one strand
to the next.
Connectors
included at
each end of
the 59H attach
to the buckles
of 36W Tensioners.
|
Warning Sign #42
By law, by courtesy
or dissuasion must
be set on post every
300ft
|
Scissors #CUT1
To cut the tape easily,
order the scissors with
serrated blades.
|
Switch #52
Attached to the gate post, in a
simple gesture, it switches the
electricity OFF or ON.
The golf ball has the big
advantage of being visible
from afar. |
Ground Rod #GR5
 |
#GR5 :Ground rod #GR5.
The 5 ft. galvanized ground rod
comes with a clamp and is
shaped to penetrate hard soil.
The ground rod connects to
the negative terminal of your fence charger.
|
|
|
